Thinlines, Plany Gitar

[ Pobierz całość w formacie PDF ]
72 Thinline
where file was posted
the area around the f hole
on the inside of the cap is
routed to a thickness of 1/8
so that the edges of the cutout
aren’t the full thickness of the cap
the control route has solid walls
- no chamber in this area unless you design it otherwise.
for balance, weight here might be a good thing.
because of the way the jack hole hits the control route,
you may want to consider drilling the jack hole before routing.
it scaled showing .3 and .6 radii being used.
redrawn here to show that either 1.125 or 1.25
and .625 drill bits work just as well.
with a 7/8 bit and a hand drill, it’s a potential wrist twister
when the bit hits the open area on one side.
with a drill press, it will put your clamping to the test.
Classic Player Thinline
switch
wire channel
in back only
otherwise, it’s back access with cover
69 & 90s Thinline
69 button
90s button
binding
drawn as .08
the control hole in the cap is an approximation
p’up wiring channels on body only - not top/cap.
when gluing on the top, having it face down will
keep excess glue from running down the sides
of the chambers and channels
Gone Fishing
if putting a switch here,
cut a channel
word has it that you can fish mini pots in after the cap in glued on and the body finished.
place pots and switch for looks or to fit your hands
chamber worksheet
[ Pobierz całość w formacie PDF ]

  • zanotowane.pl
  • doc.pisz.pl
  • pdf.pisz.pl
  • shinnobi.opx.pl
  •